Mermade Hair

Interchangeable Blow Dry Warm Air Brush

Airstyler

Introducing the interchangeable hair dryer brush from Mermade. With one base and three heads, you can dry, straighten and style your hair with a single device. Here's how it works: dry the roots and excess water with the pre-styling attachment. Then choose your fighter. The oval volume head (2.3") provides epic curves and bounce for the ultimate salon-quality blowout. The round curl attachment (1.25") conjures loose curls with ease. Thanks to the detachable attachment, it's the only tool you need to pack in your suitcase. The blowout of your dreams is just one appliance away.

• Flexible bristles
• Three heat settings
• 360° airflow
• 60 mm shaft
• Ionic technology
• Powerful - 125V~ 50-60Hz 1800W
• 2,5 m rotatable cable
• Device warranty 2 years

Application:

Step 1.Dry the hair with a towel so that it is damp. Slide the button up to turn on the device and select the desired settings. The red light will indicate "ON". Dry the roots with the pre-styling attachment and remove excess water.

• Cool - cool function, low power
• Low - high heat, low power
• Hot - high heat, high power

Styling tip: Prep your hair with a heat protectant each time you heat it. For added volume and control, use a styling mousse or root spray.

Step 2-Separate hair into 2-inch sections using our Grip Clips. Use the 60-mm attachment to start with the lower sections. Place the 60mm oval brush near the hairline and slowly brush away from the head. Continue to do this to remove moisture and dry each lower section. For added oomph, you can wrap the ends of your hair around the attachment for a sweeping blowout look.

Step 3 For more defined curls, switch to the 32mm attachment. Wrap the hair around the attachment while pulling down and twisting the device at the same time. This will give you the curve and curl you usually only get at the salon.

Step 4, once you've dried your hair, slide the knob down to "OFF". Set your blowout with hairspray for extra hold. Allow the interchangeable blow dry brush to cool completely before removing and storing the heads.